2014-Up Toyota Tundra Generation 4/5 T-Style Radio Installation

INSTALLATION VIDEO:

BOTTOM BOLT ACCESS:

When installing the bottom bolts on the brackets attached to the radio, access for them will be gained by removing the two blank plugs on the face of the radio:

NOTE: pop these covers off from the back prior to mounting the radio so you don’t have to try and pry them out later. :- )

2020 TUNDRA FACTORY AMP TURN-ON:

On Non-JBL 2020 Tundras, you may have a factory amplifier that runs the speakers in all four doors that may not be triggered properly in the Linkswell harness. This will result in sound coming from ONLY the front and rear tweeters. If this is the case, you will need to verify that the factory amplifier is being turned on.

There is a factory amp turn-on wire in the factory harness (as show below) that requires a 12 volt input to turn on the factory amplifier. If this lead is not populated on your 2020 Tundra Linkswell harness, you will need to tap the ORANGE “AMP EN” lead from the Linkswell harness into the SKY BLUE factory wire as shown below:

PLUG DESCRIPTION:

If you're confused , you can also feel free to contact our excellent customer service team to help you solve all your concerns(Contact Us). Our car stereo adopts plug and play installation method. Each of our plug connector is labeled , easy to identify, even completely inexperienced people can easily install